Effects of detector sensitivity and resolution on induction time reading

Noriaki Kubota*, Masanori Kobari, Izumi Hirasawa


研究成果: Article査読

11 被引用数 (Scopus)


The effects of sensitivity and resolution of a nucleation detector on induction time were mathematically analysed. The induction time was defined here as the time at which the number density of crystals nucleated under isothermal conditions had reached the minimum detectable number density of crystals (N/M)det. The value of (N/M)det depends on the detector used, and therefore can be called the detector sensitivity. Meanwhile, the detector resolution is defined as the minimum detectable crystal size L d. The equation for induction time tind was derived for a simplified case wherein secondary nucleation and concentration reduction were both neglected. For a more general case where such a simplification cannot be made, the induction time tind was calculated numerically. The sensitivity and resolution had effects on induction time. The induction time increased as the sensitivity decreased (i.e., the value of (N/M)det increased). It also increased with a decrease in the resolution (i.e., an increase in the minimum detectable size Ld). The effect of nucleus size L0 on induction time tind was also analysed. The analysis suggested that the induction time in an actual experiment, where the minimum detectable size Ld would be much larger than the nucleus size L0, was independent of nucleus size itself but was affected by the resolution Ld. The interfacial energy of a crystal nucleus in solution that is deduced from the widely used plot of ln tindvs. 1/(ln S)2 (S: supersaturation ratio) was pointed out to be questionable. The effect of agitation rate (or stirrer speed) on induction time was also discussed.

出版ステータスPublished - 2014 2月 14

ASJC Scopus subject areas

  • 化学一般
  • 材料科学一般
  • 凝縮系物理学


「Effects of detector sensitivity and resolution on induction time reading」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。