抄録
The purpose of this study is to establish a method of measuring precisely the seismocardiogram (SCG) of a patient who lying in an open magnetic resonance imaging (openMRI) machine for myocardial ischemia monitoring during surgery. Vibration isolation was examined by analyzing the gantry vibration during MRI scanning and the SCG of a healthy volunteer. The MRI gantry vibration had maximum amplitude of 2.5 m/s2, which are several peaks more than 100 Hz up to 500 Hz. Up to 94% reduction in amplitude was observed in the patient bed vibration under both T1-weighted and T2-weighted sequences. The power spectrum center of the patient bed vibration was more than 30 Hz. The maximum amplitude of SCG was 0.92 m/s2 and a FFT analysis revealed that the SCG was not higher than 25 Hz. The signal-to-noise ratio between the SCG and the patient bed vibration was calculated to be from 4 to 7. These results demonstrate that the peak acceleration of the SCG can be monitored during openMRI scanning. In conclusion, vibration analysis showed the feasibility of using the piezoelectric acceleration sensor for seismocardiogram measurement in the openMRI-guided operating theater.
| 本文言語 | English |
|---|---|
| ページ（範囲） | 1426-1433 |
| ページ数 | 8 |
| ジャーナル | JSME International Journal, Series C: Mechanical Systems, Machine Elements and Manufacturing |
| 巻 | 46 |
| 号 | 4 |
| DOI | |
| 出版ステータス | Published - 2003 12月 |
ASJC Scopus subject areas
- 機械工学
- 産業および生産工学